Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - MannyD

Pages: [1]
I want to create something like this.

I've created the concrete material and 3 differing tones, but I want to tile and randomise them. I'm new to this, and I can't find anything online that can guide me through such a process.

Anyone willing to help me out here?


I can see there is a colour variation option but not a tonal variation slider. I just want add 2-3 different tones to the tiles.

How do i go about doing this?

Hello! I am somewhat new myself, but while experimenting, I have gotten something similar to what you are asking with:
  • Blending a grunge map, and perlin noise
  • Then a directional warp
  • And adjusting with levels and perhaps a gradient blended with that.

Try that and see where it gets you. You can also try masking out that initial grunge map and noise blend before continuing if you want to isolate your sag in the brick to the lower region.

Cheers, I'll give that a go!


I'm fairly new to SD. Hi.

What would be the best way to get these cracks highlighted in red, to appear only on the lower part of each tile?


Pages: [1]