[SOLVED] Corrupted Distance Nodes

[Dominic Sagona 1]

I opened up a project to work on today and ALL of my distance nodes are corrupted. They are all stretched vertically. They were completely fine before until I reopened the project. I copy/pasted the same node setup into a new project and they work as intended/normally (photos attached for reference - corrupted version on the right) When I try to recreate my node setup in my current project, the distance nodes stretch the inputs vertically - as if they are broken. Not sure what the problem is here but I would sure love a solution. Can I revert back to an older version of SD possibly? Currently on 11.1.2.

Please halp. xo

Thanks for your time.

[Dominic Sagona 1]

***FIXED!!***

So I'm assuming this was my fault, probably being too clicky clicky with my mouse, but after installing an older version of SD to troubleshoot, I still had the same problem.    So...must be a project setting then, right? Yup. Turns out my Pixel Size Width was set to .09.    Set this back to 1 and good to go.