Add height/normal change to stack?

[nsieversX]

So is there a way to add some height information (say based on a mask) to my stack?  The bitmapToMaterial isn't really picking up an outer edge that should be a gap between tiles.  I tried doing something like adding paint with a mask, and then almost if you could do a negative height or negative air bubble.  Not really seeing another layer to do it. 

Hopefully that makes sense.

[Baptiste M]

Hello,

It's not possible yet. What you can do to add some information on your height map is to use two filters:
- Adjustments
- Height Modulation

Cheers

[nsieversX]

Thanks, I gave them a try but it really needs to be applied to a specific area.  Probably end up having to take it into Designer or something.

I would definitely say for the future having some sort of masking system would be incredibly powerful.  Even if it was just putting a mask map option, like the paint layer, on a majority of layers so that filters can be applied to user defined areas only.

cheers,
Nic